Axial Racing SCX-10 Honcho & Dingo Steering Link Upgrade, Black Anodized - ASCX10-22403-02-BK by Jazrider  [ASCX10-22403-02-BK]

Axial Racing SCX-10 Honcho & Dingo Aluminum Steering Linkage
Price:
AUD$9.92
Brand:
JAZRIDER
Model:
ASCX10-22403-02-BK
Condition:
Brand New
Write a review

Steering geometry and tuning impact

This black anodized aluminum steering linkage upgrades the Axial Racing SCX-10 Honcho and Dingo to provide firmer steering input and reduced flex. It is supplied as a scale accessory for model use only.

Installation notes: take out the stock plastic link, check thread fit on knuckles and the servo horn, then move over any existing rod ends. Centre the servo before making final adjustments, then set transmitter endpoints and steering trim. Confirm there is no binding at maximum steering angle.

Tuning role: a stiffer linkage sharpens steering response and stabilizes toe under load, allowing finer tuning of servo endpoints, drag link height, and steering ratio. Treat the part as one element in a broader steering setup rather than a single fix.

How does this affect steering feel on trail runs?

Expect crisper, more direct steering feedback with less compliance under load, which helps on steep or technical sections where consistent geometry matters.

Should I change servo endpoints after install?

Yes. Recenter the servo and then set endpoints and dual rates as needed to match the new linkage stiffness and avoid overloading the servo at full throw.

Is it compatible with progressive steering setups?

It works with a variety of link geometries, but adjust drag link position and rod lengths to maintain desired steering arc and to keep bump steer in check.

Copyright © 2008-2026 rcjaz.com.au All rights reserved