The 4pcs set of alloy hex adapters is produced for Axial Racing SCX10 scale crawlers and compatible hubs that accept a 12mmx6mm hex interface. The four adapters provide a consistent mating point between wheel and hub when swapping wheels or installing aftermarket rims.
This component is a simple, low-profile replacement with a neutral finish intended for scale RC use only. Confirm the hub and wheel hex dimensions match 12mmx6mm before purchase. Installation depends on the vehicle's existing hardware, so keep original screws and fittings unless a wheel supplier specifies otherwise.
For setup and tuning, these adapters help preserve concentric wheel mounting and can cut down on play at the wheel interface when used with appropriate hub hardware. Maintain clean mating surfaces and recheck fasteners as part of routine checks after runs.
Copyright © 2008-2026 rcjaz.com.au All rights reserved