AXIAL Racing SMT10 +2mm Aluminium Wheel Hex Upgrade - MJ0102/+2MM by GPM  [MJ0102/+2MM]

Upgrade wheel hex for SMT10 chassis

This machined aluminium wheel hex is supplied as a 2pcs set and is made for AXIAL Racing SMT10 platforms, offering a +2mm offset to widen track without modifying wheel backspacing. It is aimed at hobbyists tuning wheel position and handling on SMT10 models.

Purpose and advantage: by moving the wheel mounting face, the hex lets you alter stance and clearance for setup or to avoid interference. The aluminium build delivers firmer retention than plastic parts and helps maintain alignment under load during spirited running.

Fitment notes: install these hexes in place of the stock parts using your existing axle and wheel hardware on SMT10 builds. After fitting a +2mm offset, verify tyre clearance and suspension travel, hand-tighten then torque to your normal wheel hardware settings. Not designed for full-size vehicle use.

Included hardware: the package supplies the wheel hexes plus the small fitting parts commonly needed during installation, listed here for clarity: 2pcs wheel hex, 2x10.9 steel pin - 2pcs, 2x7 steel pin - 2pcs, 2.5x2.5 screw shaft - 4pcs, 1.2 hex socket key - 1pc.