This gear set is a compact service replacement for Axial platforms and close variants, intended to transfer drive torque within the vehicle drivetrain. Components are produced from hardened steel #45 and use a spiral (helical) tooth profile to aid smooth gear meshing under load.
The listed package includes a differential bevel gear, a pinion gear, and an M4*2.5*12 screw pin. The M4*2.5*12 screw is called out as not suitable for the Wraith chassis, so use the original Wraith screws when fitting that model.
Use these parts to renew worn bevel and pinion contact faces, retain correct mesh geometry, and provide a tough, serviceable option during drivetrain maintenance or tuning. Follow standard gear mesh setup and confirm shaft alignment before final assembly.
Fit this set when replacing worn bevel or pinion parts on compatible Axial-based RC rigs, and double-check screw compatibility for Wraith before tightening everything down.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
