The RR237SAN shaft assembly is a scale replacement intended for AXIAL RR10 Bomber platforms, using an aluminum 6061-T6 alloy shaft body combined with hardened steel #45 cross head sections to lower rotating mass while retaining load-bearing strength where steering articulation is concentrated.
The universal swing cross head enhances steering angle and articulation during slow-speed crawling. A pin-lock mechanism secures the head to the shaft to reduce the risk of loosening under repeated use. White silicone o-rings are supplied to separate the head from the shaft body and reduce metal-on-metal contact.
Adjustable lengths accommodate common front and rear driveline setups: front 116-126mm, rear 147-157mm, assisting fitment with typical RR10 Bomber link geometry. This kit is intended for RC chassis tuning and repairs, not full-scale vehicle applications.
Install this set when worn shafts need replacement or when tuning link lengths for improved steering articulation on RR10 Bomber rigs; always confirm measurements and fit before final assembly.
Copyright © 2008-2026 rcjaz.com.au All rights reserved