This machined alloy front and rear damper mount suits Axial Racing SCX10 chassis and includes several top mounting holes so you can adjust shock angle and chassis height without cutting or bending the factory towers. It is sold as an upgrade part for fine-tuning suspension geometry on scale crawlers using SCX10 platforms.
Design notes: the multi-hole pattern lets you relocate the shock top eye up or down in relation to the chassis centerline, changing leverage and effective spring rate. Use the mount to refine axle articulation, reduce body clearance issues, or change roll behaviour while retaining current shock absorbers where possible.
Installation overview: the mount takes the place of stock tower attachment points and uses compatible chassis screw locations. Verify fastener length and thread engagement, then check for any interference throughout full suspension movement after installation.
Use this mount when you need clear, repeatable changes to shock geometry for crawling or trail runs on SCX10 vehicles; always confirm fit before final torque.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
