This 8pcs rod link set is an RC-scale replacement purpose made for the AXIAL SCX-10 II chassis, aimed at front and rear linkage locations on the Jeep Cherokee configuration. The set uses aluminium shafts combined with plastic ball ends, and is designed for a 330mm wheelbase.
Install this set to replace fatigued factory links or when adjusting roll centre or steering geometry during scale crawler tuning. The plastic ball ends reduce binding with standard threaded rod adaptors, while aluminium rods deliver improved straightness and rigidity versus stock plastic components.
Fitment advice: verify the 330mm wheelbase before fitting, transfer compatible original hardware where useful, and confirm each linkage length and end orientation to maintain intended suspension movement and steering geometry.
For scale crawler drivers using an AXIAL SCX-10 II Jeep Cherokee with a 330mm wheelbase, this 8pcs aluminium rod link pack gives a direct replacement focused on reliability and consistent linkage behaviour.
Copyright © 2008-2026 rcjaz.com.au All rights reserved