Axial SCX10 II Off-Road 25mm Wheel Hex Adapters SCX2010/25MM by GPM  [SCX2010/25MM]

25mm hex adapters for wider SCX10 II stance

These aluminium hex adapters extend effective axle width by 25mm to widen the track on Axial SCX10 II models, helping with roll control when negotiating rough, technical terrain. They are intended for use with 4mm threaded wheel shafts and wheels that accept a 4mm hub bore.

The retention system includes a Delrin centre collar for precise wheel location, an O-ring on one side and a spring-steel retaining ring with springs and washers on the other to eliminate axial lash. A stainless steel cap-head screw secures the stack and keeps the hex locked to the shaft during heavy traction situations common in rock crawling.

Installation and setup: verify your shaft thread and wheel bore are both 4mm, check for wheel runout after assembly, and confirm sufficient clearance to suspension components and the body when the wider stance is fitted. A wider track stabilises the vehicle but may put extra load on bearings and linkages, so inspect bearing fit and steering geometry afterwards.

• Includes: Stainless Steel Cap Head Screw 4x12 - 2 pcs
• Includes: Metal Shim 4.3x1 - 2 pcs
• Includes: Metal Ring - 2 pcs
• Includes: Steel Pins 2x10 - 2 pcs
• Includes: O-Ring 2x9 - 2 pcs