Axial SCX10 II Steel Main Centre Drive Shaft JR-AS213 - upgrade for SCX10 II by Jazrider  [JR-AS213]

Axial SCX10 II Steel Main Center Drive Shaft
Price:
AUD$18.46
Brand:
JAZRIDER
Model:
JR-AS213
Condition:
Brand New
Available in shop
Write a review

Performance and tuning notes

This JR-AS213 steel main centre drive shaft is an RC replacement part for the Axial SCX10 II chassis. It is a focused drivetrain piece that transmits torque between the transmission and axles in slow-speed crawling and technical trail scenarios.

When installing, prioritise alignment and smooth engagement: check the driveshaft spline fit, yoke engagement and ensure there is no binding through full suspension articulation. Switching to steel affects rotational inertia and may change wear patterns on drivetrain bearings; address lubrication and bearing condition during the swap.

Use JR-AS213 to remove play or substitute a damaged factory centre shaft, and verify clearance with suspension links and skid plates while articulating. Periodic checks after aggressive runs help catch wear at mating surfaces and universal joints before they cause failures.

Will JR-AS213 affect low-speed throttle feel?

A heavier steel shaft can slightly alter low-speed response due to increased rotational inertia; ensure bearings are healthy and lubricated to minimise friction.

How do I check for binding after fitting?

Rotate the drivetrain by hand through full suspension travel and observe for snagging or resistance; re-check spline seating and yoke clearance if you detect binding.

Is JR-AS213 suitable for heavy-duty crawler builds?

It is suitable for strengthened builds, but monitor bearing and joint wear since steel parts can increase load on mating components.

Copyright © 2008-2026 rcjaz.com.au All rights reserved