This drive axle upgrade set fits AXIAL SCX30 models and is produced by GPM. Parts are crafted from 4140 medium carbon steel and finished in hardened black to give a strong, wear resistant driveline suitable for rigorous rock crawling and trail use on 1/30 scale crawlers. The 3mm widened stubs widen the axle track to improve lateral control, allow more tyre options and help with steering clearance.
Fitment note: while the widened stub design works with most SCX30 variants, the SCX30 Ford Bronco's low body may cause interference with the wider axles. For that chassis it is recommended to fit SCX30/26FR 26mm shocks with this kit to raise ride height and avoid body contact.
The set replaces original front and rear drive components and includes brass spacers for correct alignment. This upgrade prioritises driveline strength and track width changes rather than altering suspension geometry or motor characteristics, so verify alignment and clearance before final installation.
AXI-3324+AXI-3320
Fit this GPM axle set to gain a tougher steel driveline and a modest track increase on SCX30 crawlers; always double check body clearance and driveline alignment after fitting.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
