AXIAL SCX6 Precision Spiral Ring & Pinion 32T/9T 1.35 Mod SCX60932TS by GPM  [SCX60932TS]

Precision spiral-cut ring and pinion for SCX6

This aftermarket ring and pinion set is intended as an RC-scale drivetrain replacement for the AXIAL SCX6 chassis. The components are manufactured from hardened 20Cr carbon steel with a dark protective finish and feature spiral-cut tooth geometry to improve running smoothness and spread contact across more teeth than straight-cut alternatives. The module is 1.35 with a 32-tooth ring and 9-tooth pinion for diff housing installation.

The set transmits motor torque through the differential to the axle shafts; spiral-cut meshing typically reduces noise and point loading when the gear mesh is carefully adjusted. It is supplied as a higher speed ratio option versus the factory 12/43T 1.0 mod set referenced by AXI252007; check clearances and mesh before final assembly.

Setup guidance: confirm the 1.35 pinion seats correctly, set backlash to a safe clearance, verify bearings and diff case for play, and use proper gear lubricant on the teeth. Perform a short, low-speed run-in and then re-check mesh. For model use only.

On SCX6-based crawlers this hardened spiral-cut gear pair offers a robust alternative to stock ratios, delivering smoother engagement when correctly installed and maintained.