This RC-scale front bumper mount is designed specifically for the Axial 1/6 SCX6 Jeep platform and is sold under model JR-SCX605-TI. Constructed from aluminum with a Titianum finish, the part is intended for scale bumper positioning and to provide a firmer front-end mounting point on modified rigs.
Functionally, the mount acts as a stable anchor for bumper assemblies and helps maintain alignment when the vehicle is under load during trail or crawl sessions. The design prioritizes fit and stiffness to support accessory bumpers and recovery fittings rather than purely cosmetic use.
Installation notes: the component is made to align with the SCX6 front mounting pattern; typical RC hand tools like hex drivers are usually sufficient. Double-check bumper hardware compatibility and hole spacing before fitting, and use thread-lock or appropriate washers for metal fastenings.
For SCX6 builders aiming to tune front-end response or mount heavier accessory bumpers, this aluminum front mount offers a solid replacement option to improve rigidity and mounting accuracy.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
