Designed as an aftermarket steel rear drive shaft for Axial Racing Wraith series rigs, this gunmetal-finished axle is a direct-replacement part intended to resist wear and bending under heavy trail use. It offers a clear strength advantage over lighter stock components.
Replacement follows common Wraith rear axle procedures on 1/10 chassis: inspect axle cups, wheel hexes, and ball bearings, fit the shaft, then confirm all fasteners are torqued correctly to the maker's specs. Rotate the drivetrain by hand to confirm there is no binding.
From a tuning viewpoint the AW-23010-GU raises axle stiffness and durability while leaving gear ratios and electronics unchanged. It pairs with factory differentials and bearing setups and is suited for aggressive trail and rock use where steel parts are preferred.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
