Axial Yeti Aluminium Servo Tie Rod Adjustable YT024A by GPM  [YT024A]

Adjustable steering link for Axial Yeti

This RC-scale adjustable servo tie rod suits Axial Yeti rock machines and is supplied as 1 pcs. The assembly combines an aluminium threaded rod with black plastic end fittings to form a compact steering link ideal for off-road tuning.

The tie rod replaces the servo-to-knuckle connection and functions as a steering setup part. Adjusting the threaded portion alters toe and steering throw in fine increments so you can dial handling without changing core suspension components.

To install on compatible Yeti steering systems: remove the original link, align thread directions where applicable, and ensure both ends have sufficient thread engagement. Confirm the plastic ends locate properly on the linkage pins and that the rod clears full suspension travel.

Service and setup advice: check the plastic end fittings for wear after rough use, verify the rod runs straight after installation, and ensure there is no binding through full steering sweep. Recheck and torque fittings after a short run.