Axial Yeti Rear Cage Mount Aluminium Upgrade YT311A by GPM  [YT311A]

Aluminium rear cage bracket for the Yeti

This aluminium rear cage mount is an aftermarket component for the Axial Racing Yeti platform, made to restore or reinforce the rear cage mounting points on the RC rock racer. It is a direct-fit option where chassis rail spacing and mounting bushes align with the Yeti cage configuration.

The item acts as a structural link between the rear cage and chassis rails, limiting flex under load and helping maintain body mount alignment during demanding runs. Aluminium gives better wear characteristics than many plastic mounts, assisting with consistent alignment after knocks and impacts.

Fitment is straightforward for experienced modders: remove the existing mount hardware, check the aluminium piece for correct hole alignment, then secure it with the original fasteners or suitable equivalents. Confirm thread engagement and use thread locker where preferred. No special tools are required beyond common hex drivers.

As part of tuning this mount helps deliver repeatable rear cage position for suspension and body setup changes; it should be used alongside measured adjustments rather than to mask other chassis damage.