Axial Yeti Rear Lower Chassis Link Aluminium YT014L by GPM  [YT014L]

Rear lower aluminium link tailored to Axial Yeti

These aluminium rear lower chassis links are supplied as a pair and are intended as a replacement for Axial Yeti vehicles. They act as a fixed-length connection between the rear lower mounts and the centre chassis, creating a more direct load route for suspension forces and helping to maintain geometry under dynamic loads.

Being aluminium, the links give a firmer chassis response compared with plastic parts and can change how the rear reacts under both acceleration and braking. That stiffness may alter rear traction and the feedback you feel at the wheel, so expect a different handling balance after installation. Fitment is straightforward where stock mounting points are retained.

Installation notes: this is a direct replacement part so reuse original mounting hardware and the factory orientation. During installation verify pivot movement and correct fastener torque, and ensure adequate clearance to nearby suspension and driveline parts before you run the car. Check for loosening or fatigue routinely.

Tuning role: aluminium links are used to reduce unwanted flex, stabilise roll and control squat characteristics. The change is normally less dramatic than adjusting shock springs or arms but gives more consistent axle geometry for repeatable setup adjustments.

Select this aluminium pair to improve rear geometry stability on Axial Yeti rock racer builds while keeping maintenance simple.