Axial Yeti Rear Sway Mount Upgrade YT312 by GPM  [YT312]

Rear sway mount and cage tie-in for Axial Yeti

This 9pcs kit addresses the rear anti-roll linkage and cage attachment points used on Axial Racing Yeti models in rock racing environments. The components are an aluminium aftermarket mount and wire that replace or relocate the factory sway bar and cage anchors to give controlled rear roll and a secure cage connection.

Designed for hobby-grade chassis work, these scale parts for Axial Yeti vehicles focus on three roles: creating a solid mounting point for the rear sway bar, providing a place to fasten cage wiring or supports, and allowing measured tuning changes to rear roll resistance without altering suspension geometry.

Installation fits the existing rear mount points on the Yeti chassis. Common steps include removing stock mount hardware, seating the aluminium mount into the factory position, routing and securing the supplied wire for cage attachment, and confirming there is no interference with suspension travel. Basic hand tools and a hex driver are normally enough; final torque checks and binding inspection are recommended.

The mount is intended for adjustment and tuning rather than major structural work. RC enthusiasts fit this item to dial in rear anti-roll stiffness and to secure cage tie-ins for trail and rock racing, keeping the modification reversible for restoring the stock configuration.

This aluminium rear sway bar and cage mount set provides a compact aftermarket route to controlled rear roll changes and a dependable cage attachment while keeping installation reversible and serviceable with common tools.