Axial Yeti Steering C-hub Upgrade, Aluminum Gunmetal - YT-25001-GU by Jazrider  [YT-25001-GU]

Axial Racing Yeti Aluminum C Hub Carrier (Gunmetal)
Price:
AUD$14.86
Brand:
JAZRIDER
Model:
YT-25001-GU
Condition:
Brand New
Write a review

Tune-focused aluminum C-hub for Yeti

This gunmetal aluminum C hub carrier is an RC-scale replacement crafted for the Axial Yeti platform, marked YT-25001-GU. It swaps in for the stock C-hub carrier using the same bolt pattern to provide a firmer connection between the steering knuckle and suspension upright.

The primary function is to support the steering knuckle pivot and hold wheel alignment under load. An aluminum carrier cuts flex compared with plastic, helping the chassis retain steering geometry during high-speed turns and rough sections.

Installation follows a simple replacement routine: remove the wheel and knuckle assembly, unbolt the stock C-hub carrier, and secure the aluminum unit with the existing fasteners. After installation, move the steering through its full range to check clearance and movement.

Tuning tip: because aluminum stiffens the steering pivot, you may notice quicker steering inputs. Reassess toe and steering centring while tuning to fine-tune handling behaviour.

Will this change require different shock or spring settings?

Not necessarily, but because the steering response tightens, you might soften front springs or adjust damping slightly to rebalance traction and turn-in feel.

How should I verify steering centring after fitting?

With the wheels on the ground, centre the servo and then confirm the tie rods give equal toe on both sides. Fine-tune at the servo saver or steering linkage as needed.

Is YT-25001-GU compatible with all Yeti variants?

The carrier is designed for Axial Yeti platform fitment using the standard C-hub mounting pattern; verify compatibility with specific Yeti variants before purchase if your chassis has been modified.

Copyright © 2008-2026 rcjaz.com.au All rights reserved