Made for Axial Racing Yeti chassis, this steering assembly rod is listed as model GYT049 and corresponds to the AX31122 reference. It is supplied as a single replacement rod for instances where the original linkage needs replacement or a stiffer option is preferred.
The rod functions as the connection between the servo output and the steering knuckles, providing control of front-end alignment and motion. The combined graphite and aluminium construction is chosen to reduce flex while keeping additional weight minimal, aiming for a steadier steering feel without modifying steering geometry parts.
Installation follows standard link replacement steps: remove the old rod, compare length and pivot setup to AX31122, transfer usable hardware, and mount the new rod. Tighten and check fastener security, then cycle steering through full travel to confirm no interference with suspension or servo travel.
For tuning, fitting a graphite-and-aluminium rod will typically firm up steering response and preserve alignment under load. That crisper feel can benefit lap consistency or aggressive trail driving. After fitting, recheck toe and servo travel limits to maintain safe, predictable handling.
Sold as 1 pcs, intended for RC-scale Axial Racing Yeti models only.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
