Axial Yeti / Yeti XL 32 Pitch 17T Steel Pinion Gear YTL017TS by GPM  [YTL017TS]

Axial Racing Yeti XL Steel #45 Pinion Gear 32 Pitch 17T (AX31226) - 1pc set (For Yeti / Yeti XL) - GPM YTL017TS
Price:
AUD$8.44
Brand:
GPM
Model:
YTL017TS
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="Axial Racing Yeti XL Steel #45 Pinion Gear 32 Pitch 17T (AX31226) - 1pc set (For Yeti / Yeti XL) - GPM YTL017TS" title="Axial Racing Yeti XL Steel #45 Pinion Gear 32 Pitch 17T (AX31226) - 1pc set (For Yeti / Yeti XL) - GPM YTL017TS"

32 pitch 17T steel pinion for Axial Yeti platforms

A single-piece #45 steel pinion supplied as a 1pcs set, made for 32 pitch gear systems and intended for Axial Yeti and Yeti XL vehicles. It fits onto the motor pinion shaft to tweak final drive ratio or to replace a degraded pinion.

Fit this pinion to alter acceleration and top speed balance or to restore proper gear mesh after wear. Confirm motor shaft size, set an appropriate mesh with the spur gear, and ensure the gearbox turns freely before running. Avoid overtightening mesh and perform a no-load spin-check after installation.

Verify spur gear compatibility with 32 pitch specification and confirm shaft fit prior to installation. For hobby RC use only.

What is the recommended use for this pinion?

It is best used to adjust gearing on 32 pitch transmissions to tune acceleration or replace a worn motor pinion.

Do I need to change the spur gear too?

If you change tooth counts significantly you may need a different spur to keep correct mesh; small adjustments usually work with the existing spur.

How tight should the grub screw be?

Tighten the grub screw enough to prevent slippage but avoid over-torquing which can score the shaft; use a locking compound if desired and recheck after a short run.

Copyright © 2008-2026 rcjaz.com.au All rights reserved