Axial Yeti XL Adjustable Steering Tie Rod Spring Steel YTL024A by GPM  [YTL024A]

Axial Racing Yeti XL Spring Steel Adjustable Servo Tie Rod With Black Plastic Ends(AX31033) - 1pc - GPM YTL024A
Price:
AUD$4.87
Brand:
GPM
Model:
YTL024A
GTIN:
4894538244441
Condition:
Brand New
Write a review
alt="Axial Racing Yeti XL Spring Steel Adjustable Servo Tie Rod With Black Plastic Ends(AX31033) - 1pc - GPM YTL024A" title="Axial Racing Yeti XL Spring Steel Adjustable Servo Tie Rod With Black Plastic Ends(AX31033) - 1pc - GPM YTL024A"

Adjustable steering tie rod for the Yeti XL

Supplied as a single unit (1pc), this servo tie rod is built for Axial Racing Yeti XL setups. It uses a spring steel shaft combined with black plastic end fittings to deliver a sturdy centre section with protected pivot points for everyday off-road use.

Its adjustable length helps builders fine-tune steering geometry without needing multiple replacement links, allowing you to adjust toe and Ackermann behaviour on the Yeti XL chassis. Use it as a direct replacement where the stock mounting points and ball studs are compatible.

Fitting is simple for those with RC experience: link between the servo horn and steering arm using your vehicle's existing linkage hardware, then test and re-adjust during setup changes to steering throw or suspension travel.

Will it fit with aftermarket steering arms?

It will fit when the aftermarket arms use the same ball stud spacing and mounting points as the Yeti XL stock parts.

Any routine maintenance needed?

Check the ends and ball studs regularly for wear, ensure threads are locked after adjustment, and replace plastic end fittings if they show excessive play.

Is this suitable for competition use?

The spring steel shaft provides good consistency for club-level competition, though top-level racers may choose different link materials based on track demands.

Copyright © 2008-2026 rcjaz.com.au All rights reserved