Ball-End Hex Driver for RC 3.0mm, 110mm Shaft - Arrowmax am-429130  [am-429130]

Ball-end driver built for setup and adjustments

This Ball Driver Hex Wrench is sized for 3.0mm hex fasteners commonly used on RC cars and other models. The long 110mm shaft helps get into recessed mounting points, while the ball-end profile gives you some latitude to turn screws at an angle when direct access is limited during setup or quick fixes.

Use it for precise fastening on servo brackets, tie rods, pinion and spur screws, shock caps and small chassis bolts. The tool is compact enough for a bench drawer yet long enough for pit-side tuning where reach matters.

Maintain the tool by keeping the tip free from burrs and debris, wiping it clean after use, and storing it in a protected slot or case to preserve the hex geometry for tight 3.0mm fits.