Bandai 5069361 LED Unit for PG Unleashed 1/60 Nu Gundam Internal Illumination Kit  [B-5069361]

Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam
Price:
AUD$169.24
Brand:
Bandai
Model:
B-5069361
GTIN:
4573102693617
Condition:
Brand New
Available in shop
Write a review
alt="Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam" title="Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam"
alt="Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam" title="Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam"
alt="Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam" title="Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam"
alt="Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam" title="Bandai 5069361 - LED Unit For PG Unleashed 1/60 Nu Gundam"

Add-on LED system for the 1/60 Nu Gundam Perfect Grade

The LED unit is an add-on lighting component intended for the PG Unleashed 1/60 Nu Gundam model. Originating in the Universal Century storyline, the Nu Gundam is the principal mobile suit in Mobile Suit Gundam: Char's Counterattack (UC 0093), characterised by heavy weapon loadouts and psycho-frame architecture. This component focuses on mechanical fit and lighting placement inside exposed frame sections and is specified for the PG Unleashed 1/60 assembly format.

Installation difficulty and gear

Difficulty: moderate. Prepare a small Phillips screwdriver, tweezers and model nippers for accessing panels and trimming any routing channels. The job expects careful wire management inside a multi-piece assembly.

Masking, painting and blend-in tips

Surface prep is optional; mask wiring and connector faces if you will paint nearby parts. The unit's visible areas can be left as supplied or finished to match the model frame depending on your display goals.

Specifications

  • Scale: 1/60
  • Grade: PG (Perfect Grade)
  • Build Level: normal

A purpose-made lighting module for the PG Unleashed 1/60 Nu Gundam, intended to illuminate internal frame and sensor regions for enhanced display presence.

Retrofit installation is possible but may require partial disassembly to access internal routing paths. Planning the cable route before final assembly will make fitting much easier.
The unit includes small wired connectors designed for PG routing. If your setup differs, adapters or minor soldering may be needed; follow the supplied connector specifications.
Yes, the LEDs are intended to backlight psychoframe or sensor sections that may be covered by translucent or open-frame parts, producing accent illumination when positioned correctly.
Minor repairs like connector replacement or wire re-routing can be done by experienced hobbyists. For component-level failures, consult manufacturer service or authorised parts suppliers.
The unit is designed to work within internal cavities and should not require permanent modification of exterior panels if installed following recommended routing and access points.

Copyright © 2008-2026 rcjaz.com.au All rights reserved