BD9 RTC Rear Graphite Suspension Arm (53mm-40mm) - Yokomo B9-RTC-01A  [B9-RTC-01A]

Yokomo B9-RTC-01A RTC Graphite Rear Suspension Arm (53mm-40mm)
Price:
AUD$16.46
Brand:
Yokomo
Model:
B9-RTC-01A
GTIN:
0639342182725
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - MRTC-BD10FF category
Write a review

BD9 RTC Rear Arm, Graphite Construction

This graphite rear suspension arm fits the RTC layout of the BD9 family and is intended as a replacement for 1/10 electric touring RC vehicles. It keeps the RTC dimensions intact, with a 53mm span between inner and outer suspension pins and a 40mm shock pivot gap consistent with the RTC setup.

Make sure your chassis code matches one of the supported items below before ordering. The arm mounts where the stock RTC arm mounts; uninstall the old arm and move any required pins or hardware across. Check pin fitment and clip security during assembly to ensure correct operation.

The graphite component is used to preserve or restore RTC suspension geometry. It is appropriate for routine servicing and simple tuning swaps where the 53mm/40mm arrangement is required, and it works with standard RC suspension pins and shock configurations for the models listed.

Supported chassis

  • MRTC-BD919
  • MRTC-BD919S
  • MRTC-BD10FF
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How does swapping to this graphite arm affect handling?

Since it matches the RTC geometry, handling changes should be minimal. Material differences may alter feel slightly under load, which can be used to fine tune rear response with spring and damper adjustments.

Can I use my existing shocks and pins with this arm?

Yes. The arm is designed to work with standard suspension pins and shocks that fit the 53mm/40mm RTC layout. Transfer your existing hardware and confirm each connection for play or wear.

Is special setup required after installation for track performance?

After fitting, run baseline tests and adjust shock position or sway settings if needed to restore the balance you prefer. Small damper or ride-height tweaks often compensate for material differences.

Copyright © 2008-2026 rcjaz.com.au All rights reserved