Cero Sport 64 Chassis Graphite Upgrade Compatible with 3Racing O-3CK001 by Factory Pro  [FP-O-3CK001]

Price:
AUD$91.17
Brand:
Factory Pro
Model:
FP-O-3CK001
Condition:
Brand New
Write a review

Track-focused graphite conversion for Cero Sport 64

The Factory Pro aftermarket conversion swaps key chassis plates on the 3Racing Cero Sport 64 Kit for graphite to adjust flex and enhance setup options at 1/10 touring scale. The upgrade is intended for users concentrating on handling precision and lap-time improvements.

Installation notes: stock composite plates are replaced with stiffer graphite components that affect how the chassis transfers weight and reacts mid-corner. You should notice reduced flex and sharper turn-in; compensate by tuning damper settings, roll bars and ride height to regain optimal balance. This is an RC accessory and must be used with compatible 3Racing components.

Specifications

  • Item Graphite conversion kit
  • Material Graphite
  • Model Number O-3CK001
  • Compatibility Only for 3Racing Cero Sport 64 Kit

Fitment information

Only for 3Racing Cero Sport 64 Kit.

Use this conversion when you want a firmer chassis platform for aggressive track setups on the 3Racing Cero Sport 64; make small tuning steps to match tyres and circuit conditions.

Does this kit include every plate for a full swap?

The listing describes a graphite conversion kit for the Cero Sport 64. Check the seller's parts list to confirm which plates are included before buying.

Will changing to graphite affect tyre wear?

A stiffer chassis can shift load distribution and affect how tyres scrub through corners, so monitor wear and adjust camber and toe as needed after installation.

Are any extra parts required to finish the conversion?

Most users will only replace chassis plates, but keep spare hardware and small shims available to fine-tune fitment and clearances during installation.

Will the conversion change battery fitment or layout?

Battery tray positions remain as per the original Cero Sport 64 Kit, but verify clearance and strap fit after installing the graphite plates.

Can I mix graphite and composite plates?

Mixing materials is possible but will produce uneven flex characteristics; for predictable handling it is usually best to follow the kit's recommended plate layout.

Copyright © 2008-2026 rcjaz.com.au All rights reserved