Compatible with Axial EXO Wheel Hex Adapter 12x9mm AX010/12X9MM by GPM  [AX010/12X9MM]

12x9mm alloy hex adapters for Axial platforms

This 4-piece 12x9mm alloy hex adapter set is intended for wheel and hub adjustment on the Axial platforms listed below. These are aftermarket adapters to change the wheel hex interface without the need to replace hubs or wheel hexes.

Apply the adapters when fitting aftermarket wheels that require a different hex size, or to fine-tune wheel track and stance. The alloy construction offers resistance to deformation under typical rock crawling and trail loads seen in scale RC use. Always confirm that both wheel hex and hub dimensions are 12x9mm before installation.

Fitting is straightforward for experienced hobbyists: remove the wheel, fit the adapter onto the existing hex or hub, then secure using your wheel's original fastening hardware. No additional tools or spare fasteners are included; check wheel runout and clearances after fitting.