Compatible with SCEADU SD Elevator Link Shaft — HI0412135 by Hirobo  [HI0412135]

HIROBO 0412-135 SCEADU SD ELEVATOR SHAFT #0412135
Price:
AUD$6.51
Brand:
Hirobo
Model:
HI0412135
GTIN:
4512895128180
Condition:
Brand New
Write a review

Fitment summary for SCEADU SD

This replacement elevator shaft serves as an RC-scale helicopter spare intended to be fitted into SCEADU SD elevator linkage assemblies. When installed correctly it restores mechanical integrity without changing the control geometry.

Installation notes: prior to installation inspect the rotor head, link bearings and retaining hardware for wear or damage, align the control horn and retaining fasteners accurately, and adhere to the original assembly's torque guidance to prevent introducing play. Only use thread locker where specified by the original assembly and avoid over-torquing small screws.

Tuning impact: the shaft itself does not change elevator rates or aerodynamics, but maintaining a straight, properly seated shaft is essential for accurate elevator response. Replace the shaft if you observe endplay, bending, or wear at the retaining points as those faults will degrade control precision.

Will replacing the shaft change my control rates?

No, swapping a like-for-like shaft maintains the original geometry and control rates; improvements are in reduced slop and crisper response if the old shaft was worn.

Should I replace bearings at the same time?

If bearings show wear or play, replace them alongside the shaft to ensure long term smooth movement and to avoid premature wear on the new shaft.

Any post-install setup recommendations?

After fitting, cycle the controls through full travel, check for free movement and absence of side play, and perform a ground verification of elevator response before flying.

Copyright © 2008-2026 rcjaz.com.au All rights reserved