Compatible with Tamiya CC-02 Rear Upper Link Arms Aluminium Upgrade JR-CC208-S by Jazrider  [JR-CC208-S]

Tamiya CC-02 Chassis Aluminum Rear Upper Suspension Link Arms (Silver)
Price:
AUD$12.64
Brand:
JAZRIDER
Model:
JR-CC208-S
Condition:
Brand New
Write a review

Aluminium rear top link arms for CC-02 layout

This JR-CC208-S rear upper suspension link arm set provides an aluminium replacement for the stock plastic upper links on the Tamiya CC-02 chassis, intended for scale RC tuning and tougher use.

These upper links control the rear suspension's top pivot points and influence roll center and toe under compression. Aluminium links reduce flex at the pivot, keeping geometry more consistent across multiple runs and delivering more predictable reactions when you change setup.

Installation typically uses the CC-02's original mounting points. Inspect the stock screws and ball studs and reuse if condition is good; otherwise fit correct OEM-equivalent hardware. After installation verify pivots move freely to prevent binding.

Tuning notes: moving to aluminium links will usually change how shock length, swaybar and anti-squat adjustments feel compared with stock parts. Make measured setup changes and trial on your chosen surface to settle handling balance.

How do aluminum links affect handling?

Aluminium links reduce pivot deflection compared with plastic, which tends to make steering responses and roll behavior more consistent, especially over repeated runs or rough surfaces.

What routine checks should I perform?

Regularly inspect ball studs and mounting screws for wear, clean pivot areas of debris, and confirm free rotation at each joint to avoid binding and premature wear.

Do these require different screws or studs?

Most installations reuse the CC-02's existing hardware; if any fasteners show wear, replace them with compatible OEM-equivalent parts to ensure secure fitment.

Copyright © 2008-2026 rcjaz.com.au All rights reserved