Compatible with TAMIYA WR01/WT01 Performance Shock Tower JR-WR101-GU by Jazrider  [JR-WR101-GU]

Tamiya WR01/WT01 Aluminum Front/Rear Shock Tower (1pc)(Gun Metal)
Price:
AUD$9.88
Brand:
JAZRIDER
Model:
JR-WR101-GU
Condition:
Brand New
Available in shop
Write a review

Performance-oriented shock mount for WR01/WT01

This gun metal aluminium shock tower is a single-piece replacement made for TAMIYA WR01/WT01 RC chassis, offering a stiffer shock mounting surface to tighten up chassis response. The finish is gun metal and the unit is intended as an aftermarket upgrade to the stock plastic tower.

Install as a direct bolt-on to the existing mounting points; check fastener engagement and thread condition to avoid cross-threading during assembly. While the part does not alter internal shock valving, its increased rigidity can influence suspension tuning and on-track behaviour.

Verify fitment and clearances on your WR01/WT01 build before final installation.

Compatibility

Made for TAMIYA WR01/WT01 chassis to reinforce suspension mounting areas and improve rigidity.

Can this tower change handling characteristics?

Yes. The stiffer mounting surface can tighten chassis feedback and alter handling. After installation, test and adjust spring rates, damping and ride height to suit the new mount stiffness.

Any setup checks recommended after fitting?

Run the suspension through full travel to check for binding, recheck camber and toe, and fine tune rebound and compression as needed to restore desired handling.

Is special tooling required?

No special tools are required beyond standard hobby tools. Ensure correct torque and inspect threads for wear when refitting hardware.

Copyright © 2008-2026 rcjaz.com.au All rights reserved