Compatible with TRAXXAS 1/8 X-Maxx 14T Steel Pinion TXM014TS by GPM  [TXM014TS]

14T steel pinion for X-Maxx drivetrains

This 14-tooth steel motor gear is intended for TRAXXAS 1/8 X-Maxx use and is listed as TXM014TS. Sold as one piece, it serves as a direct replacement or tuning pinion for motor-side gearing changes.

Fitment advice: check the motor shaft diameter and your pinion securing method before installation. Slide the gear onto the shaft, set an appropriate mesh against the spur gear, then secure the pinion with the motor's original locking device. Verify mesh at rest and after a short running period to avoid binding.

Gearing effect: a 14T pinion typically moves the setup toward a higher theoretical top speed with reduced low-end punch compared with larger pinions. Consider motor and ESC cooling when testing a smaller pinion to avoid thermal issues.

Durability note: steel construction offers increased resistance to wear compared with plated brass; still, inspect the pinion after heavy use and replace when tooth wear or deformation appears.