Compatible with TRAXXAS E Revo Steel #45 Front and Rear Pillow Balls ER007S by GPM  [ER007S]

Steel #45 pillow ball replacements for TRAXXAS steering

This aftermarket pack includes four Steel #45 pillow balls designed for TRAXXAS E Revo and the related Revo models listed below. These components are intended as direct-fit swaps for the front and rear steering pillow ball positions on RTR-scale chassis.

Installation is straightforward: remove the existing pillow balls from steering knuckles and linkage ends, inspect the mating hardware for wear or damage, then fit the steel pillow balls into the knuckles and tie rods using the original screws or retained fasteners. No modifications to the chassis are necessary on supported models.

From a setup point of view, steel pillow balls enhance pivot durability and may alter steering feel compared with rubber or nylon options; they are a common upgrade when stock parts wear rapidly. After installation confirm free movement and tighten fasteners to the recommended torque before driving.

Use this four-piece set to restore steering geometry and improve pivot longevity on the listed TRAXXAS models; verify part fit on the initial run.