Concept 60 Rear Stabilizer Seesaw H6002 - Kyosho  [KYH6002]

KYOSHO H6002 STABILIZER SEESAW CONCEPT 60
Price:
AUD$7.19
Brand:
Kyosho
Model:
KYH6002
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $6.53 each $1.31 or 9%
3+ $6.21 each $2.94 or 14%
Write a review

Seesaw link for Concept 60 stabilizer assembly

The Kyosho H6002 stabilizer seesaw replaces the pivoting link inside the Concept 60 stabilizer system. It is built to restore the intended linkage motion for Concept 60 hobby helicopters.

Fit this spare when the existing seesaw exhibits looseness, binding, or wear that undermines cyclic precision or pitch trim. Installing a new seesaw helps return consistent response and steadier low-speed hover control.

Fitting steps: remove rotor head covers or the canopy to reach the stabilizer, steady the rotor head to prevent unwanted movement, then swap in the H6002 using the original fasteners. Once fitted, check for free, symmetrical travel and run a bench trim and control range test before flight.

Tuning effect: the seesaw influences stick centring and trim; even small wear alters handling. Inspect and replace the seesaw when troubleshooting trim drift or irregular cyclic feel, and confirm link geometry after installation to regain predictable handling.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does the H6002 change flight trim or just restore factory geometry?

Installing a correct H6002 seesaw restores the designed linkage geometry; it does not change trim by itself but will remove trim issues caused by a worn or deformed part.

How can I tell if the seesaw is the cause of trim drift?

Look for asymmetric travel, visible wear at the pivot points, or play in the linkage. If those appear alongside trim drift, the seesaw is a likely culprit and should be inspected or replaced.

Will aftermarket linkages work with this seesaw?

Aftermarket links that match the Concept 60 geometry can be used, but verify thread sizes and lengths so they do not alter the intended geometry once the H6002 is fitted.

Copyright © 2008-2026 rcjaz.com.au All rights reserved