Concept 60 Tail Rotor Grip - Kyosho H6054  [KYH6054]

KYOSHO H6054 TAIL ROTOR GRIP CONCEPT 60
Price:
AUD$5.88
Brand:
Kyosho
Model:
KYH6054
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $4.69 each $2.39 or 20%
3+ $4.22 each $4.99 or 28%
Write a review

Tail grip for Concept 60 series

The Kyosho H6054 tail rotor grip is built for the Concept 60 range and links the tail rotor blades to the tail control linkage. It keeps alignment consistent so that the servo inputs transfer predictably to the rotor hub.

Ideal for enthusiasts and those maintaining their machines, this component replaces worn grips or serves as a spare during routine servicing. The geometry is intended to be repeatable so tail pitch response remains consistent after any maintenance work.

Installation pointers: check that the linkage ball or clevis seats correctly, make sure the grip turns freely with no binding, and then confirm full tail pitch range after installation. Minor shimming or slight linkage adjustments may be necessary when integrating with a tuned tail setup.

Maintenance tips: review pivot and contact areas for wear, keep all fixings torqued to specification, and change the part if any play appears that could reduce tail accuracy. This is an RC spare part only and not for use on real vehicles.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What is the recommended fitting sequence for this grip?

Fit the grip to the tail hub, attach the linkage, check free movement, then set linkage length and verify neutral position before a test hover.

Are there any setup checks after replacing the grip?

After replacement, re-confirm tail pitch endpoints, check for any binding through the full travel, and tune gyro or PID settings if the feel changes.

Can I expect instant repeatability after swapping this part?

The part is engineered for repeatable fitment, but small tweaks may be needed to match a previously dialled-in tail setup; always verify with a cautious test hover.

Copyright © 2008-2026 rcjaz.com.au All rights reserved