CR-2000 Futaba DC Peak Charger for RC Transmitters and Receivers  [CR-2000]

Futaba CR-2000 DC Peak Charger
Price:
AUD$116.72
Brand:
Futaba
Model:
CR-2000
Condition:
Brand New
Write a review

RC radio pack charger with peak cutoff

The Futaba CR-2000 acts as an RC-focused DC peak charger and battery checker for NiCd and NiMH transmitter (TX) and receiver (RX) packs plus single-cell glow starters. It applies peak-detection cutoff and features an LCD that reports input and output voltage, charge current, peak voltage, elapsed charge time and charged amount, together with an audible signal for completion or fault conditions.

Dual-channel charging lets you service TX and RX packs at the same time, with selectable current settings tailored to common pack sizes used in model radio gear. The charger needs an external DC input between 11-16V and a power source capable of delivering at least 6A. It is intended for model-scale use only, not for full-size vehicles.

Use and precautions: always observe correct polarity, prevent shorts, do not charge radio transmitter packs alongside glow starter packs, and perform charging only within the recommended ambient temperature range while avoiding direct sun exposure.

What is included

  • One Futaba 12V Battery Charger with cigarette lighter adapter and alligator clips
  • 28" (711mm) transmitter charge cord
  • 20" (508mm) receiver charge adapter cord
  • 80" (2032mm) receiver charge adapter cord

Specifications

  • Item: Futaba CR-2000 DC Peak Charger
  • Material: Not specified
  • Model Number: CR-2000
  • Compatibility: NiCd and NiMH transmitter and receiver packs, glow plug starter single cell
  • Battery Range: TX: 6-8 cells, 500-2000mAh; RX: 4-6 cells, 50-2000mAh; Glow Plugs: 1 cell, 2000-3000mAh
  • Input Voltage: DC 11V-16V
  • Operating Voltage: 10.5V
  • Charging Current: TX 0.5A-2A, RX 0.05A-2A
  • Cut Off: Delta Peak
  • Trickle Charge Rate: at 0.05 to 0.45A rate: 5 mils, at 0.5 to 2.5A rate: 70 mils
  • Dimensions: Length 6" (152mm), Width 3.4" (86mm), Height 1.4" (36mm)
  • Weight: 355g (12.5oz)
  • Includes: Charger unit, cigarette lighter adapter, alligator clips, transmitter and receiver charge cords
  • Requires: 11-15V DC power supply with output capacity of 6A or more (HCAP0250)
  • Notes: For use with NiCd or NiMH batteries only, do not short-circuit or reverse connect batteries, charge within 5-40°C, TX and RX can be charged simultaneously

Reliable and straightforward, the Futaba CR-2000 delivers peak-detection charging and a concise LCD for routine battery maintenance; adhere to the power input and safety guidelines when using it at the bench or outdoors.

Is the CR-2000 suitable for field and bench work?

Yes. Its DC input and portable size make it suitable for both workshop use and trackside servicing when paired with an appropriate 11-16V supply.

How should I care for the charger to extend its life?

Keep the unit dry, avoid prolonged exposure to sunlight, store within recommended temperatures, and check cables and connectors for wear before use.

What are the trickle charge behaviors at different currents?

At low rates (0.05-0.45A) the trickle indication is 5 mils, while at 0.5-2.5A the stated trickle indication is 70 mils, reflecting how the unit manages small top-off currents.

Can I combine charging a glow starter and a radio pack simultaneously?

No. The instructions advise against charging radio transmitter packs and glow starter packs at the same time to avoid unsafe conditions or interference between circuits.

Copyright © 2008-2026 rcjaz.com.au All rights reserved