This Jazrider front upright is an RC-scale knuckle arm tailored for TAMIYA CW-01 based platforms. Manufactured from aluminum with a red anodized finish, the upright replaces the stock unit to provide a metal component that helps maintain steering geometry during aggressive driving. The write-up concentrates on fitment, installation guidance, and tuning implications rather than making absolute performance claims.
Installation follows normal CW-01 service procedures: remove the original upright, fit the Jazrider aluminum piece, and verify there is no interference with servo or drive parts. Keep original fasteners where appropriate but examine them for wear; ensure correct ball stud and pin alignment before final torque. The part is supplied as a direct replacement for compatible CW-01 hubs; confirm fitment on your chassis before regular use.
In tuning scenarios, swapping to aluminum uprights is one method to change steering stiffness and feedback characteristics when combined with toe and caster adjustments as well as steering link geometry. After initial installation complete alignment checks and re-tighten hardware following a test run.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
