Cylinder Head Fastener Kit for YS FZ53 FZ63 - YSF5110 by YS Engine  [YSF5110]

YS ENGINE CYLINDER HEAD SCREW SET FZ53 FZ63 #F5110
Price:
AUD$6.37
Brand:
YS Engine
Model:
YSF5110
GTIN:
4560105736045
Condition:
Brand New
Write a review

Secure head retention hardware

This screw set is supplied as a replacement kit for the cylinder heads on YS FZ53 and FZ63 model engines. It includes the necessary fasteners for removing and refitting the head during maintenance, gasket changes, or tuning adjustments.

Compatibility is restricted to the listed YS FZ53 and FZ63 head assemblies. Use the set only where those engine codes are stated, as the components are intended to restore correct head-to-crankcase clamping on model engines.

Fitting advice: check thread condition and bore integrity, clean surfaces, start screws by hand to avoid cross-threading, and apply torque gradually following the engine maker's guidance. Stable head clamping supports consistent compression and makes tuning more repeatable.

Note that this kit is a small RC maintenance accessory and is not suitable for full-size engines or non-hobby applications.

Will new screws change my compression or timing?

Replacing worn fasteners restores proper clamping, which helps maintain original compression and timing settings; the screws themselves do not alter engine geometry when fitted correctly.

How should I sequence torquing the head screws?

Tighten in a progressive, criss-cross pattern and increase torque in small stages to the values recommended by the engine instructions to avoid distortion and ensure even sealing.

Is threadlocker useful for tuning stability?

Some builders use a low-strength threadlocker on head screws where advised; it can help prevent loosening during repeated runs, but follow the engine maker's guidance.

Copyright © 2008-2026 rcjaz.com.au All rights reserved