The Hirobo HI0414484 servo stay is a purpose-built bracket that establishes a 12mm servo mounting height. It provides a stable support to keep the servo shaft aligned with the airframe mounting points so control link geometry remains consistent under load.
Install this stay when you need accurate and repeatable servo placement, such as replacing worn mounts or aligning multiple servos during setup. It is listed among Eagle Freya helicopter parts, so double-check your model's mounting pattern before fitting.
Practical installation advice: orient the servo so its spline lines up with the control linkage before securing, prefer the original hole positions where possible, and tighten screws evenly to prevent shifting the bracket out of alignment. This is an accessory designed for RC helicopters only.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
