EDS 160140 Arm Reamer 4.0 X 120mm Workshop Reamer  [EDS-160140]

EDS 160140 - Arm Reamer 4.0 X 120mm
Price:
AUD$16.67
Brand:
EDS
Model:
EDS-160140
Condition:
Brand New
Write a review

High Precision Arm Reamer

The EDS 160140 Arm Reamer is a straightforward precision tool for RC model maintenance and setup. With a 4.0mm cutting diameter and 120mm overall length, it is aimed at creating true, clean holes in suspension arms to maintain smooth articulation.

Made for Accurate Hole Restoration

This tool lets you restore or refine hole bores without the guesswork. The consistent 4.0mm dimension helps match common hinge pins and hardware, while the 120mm reach assists in working around chassis obstructions.

Use in Regular Servicing

Integrate the EDS 160140 Arm Reamer into your service routine to remove burrs, correct ovalised holes, and prevent part binding. It speeds up setup and helps maintain predictable handling characteristics.

What is the best technique to avoid over-reaming?

Use gentle, controlled passes and check frequently against the hardware you plan to fit. Stop as soon as the pin or bushing seats smoothly without play.

Can this reamer be used on both left and right arms?

Yes, the tool is symmetrical and suitable for any arm orientation where a 4.0mm hole is required. Ensure consistent technique on each side for matched results.

Should I ream wet or dry when working on plastic parts?

Light lubrication or occasional cleaning can reduce heat and chip buildup, but plain, steady reaming is often sufficient on common plastic arm materials. Assess on a scrap piece first.

Copyright © 2008-2025 rcjaz.com.au All rights reserved