EDS-160125-L 2.5 x 120mm Lightweight Arm Reamer for Tuners  [EDS-160125-L]

Price:
AUD$17.32
Brand:
EDS
Model:
EDS-160125-L
Condition:
Brand New
Write a review

Clean Pivot Holes with the EDS-160125-L

The EDS-160125-L Arm Reamer is designed for precise trimming of suspension arm bores. Its 2.5 x 120mm size lets you remove burrs and small imperfections without weighing down the chassis.

How a Reamer Helps Handling

By opening and trueing arm holes, the reamer reduces lateral play and friction that can upset handling. A correctly sized bore keeps hinge pins and bearings running smoothly across rough terrain.

Recommended Uses

Great for racers and weekend bashers who swap parts or fine-tune ride behaviour. Use it for routine maintenance or when installing new arms and bushings.

Do I need any special tools to use the EDS-160125-L?

No specialist machinery is required. A hand-held pin vise or a slow-speed rotary tool with a guide is sufficient for controlled, accurate reaming.

Can this reamer be resharpened or replaced?

Reamers are typically economical enough to replace when worn. Check the cutting edge before use and swap to a new tool if performance drops.

Is the 120mm length useful for deep arms?

The 120mm length gives good reach for most suspension arms and allows steady hand control. For very shallow or very deep bores, choose the reamer length that matches your needs.

Copyright © 2008-2026 rcjaz.com.au All rights reserved