Electric Multirotor Prop 11x4.5 - APC AP11045MR  [AP11045MR]

APC PROPELLER 11x4.5MR ELECTRIC MULTI ROTOR
Price:
AUD$6.37
Brand:
APC
Model:
AP11045MR
Condition:
Brand New
Write a review

Multirotor Propeller 11x4.5 Overview

This APC AP11045MR 11x4.5MR propeller is intended as a replacement blade for hobby electric multirotor platforms that accept 11-inch class props. The 4.5-inch pitch and blade shape indicate expected thrust and handling characteristics used during setup and tuning.

The prop is produced from a durable plastic composite that offers reasonable impact tolerance and economy. Prior to flight, verify there are no chips, cracks or bends and ensure the hub fits your adapter or shaft securely.

Installation requires correct hub alignment and secure fastening to your motor shaft or adapter. Confirm thread direction and apply the appropriate torque for your mounting hardware, then recheck tightness after the first power-up flight.

To tune performance, swap props while leaving other settings unchanged to compare thrust, responsiveness and battery current. Use a static balancer for best results and recheck balance after any trimming or after hard landings to reduce vibration influence on electronics.

How will changing to this 11x4.5 prop affect performance?

Switching to an 11x4.5 blade typically alters thrust and responsiveness; expect differences in climb rate and current draw. Test on the bench and monitor battery amp draw to understand the change.

Should I compare props under the same conditions?

Yes. Keep motor, battery and environmental conditions the same when swapping props so observed changes are due to the propellers alone during tuning sessions.

What balancing routine is recommended?

Use a static balancer before each flight and after any trimming. Correct heavy sides with tape or careful material removal and then verify that vibration levels are acceptable for your flight controller and motors.

Copyright © 2008-2026 rcjaz.com.au All rights reserved