Element Enduro Front Steering Knuckles Upgrade JR-EE01-S by Jazrider  [JR-EE01-S]

Element Enduro Aluminum Front Steering Knuckle Arms Set (Silver)
Price:
AUD$15.47
Brand:
JAZRIDER
Model:
JR-EE01-S
Condition:
Brand New
Write a review

Performance Steering Knuckle Arms for Element Enduro

This aluminium front steering knuckle arms set is an RC-scale upgrade made for Element Enduro chassis users seeking reduced flex and improved steering feedback. By stiffening the steering pickup points, the parts deliver a more direct response during precise trail maneuvers and technical lines.

Installation follows the usual procedure: remove wheel, detach the factory knuckle using original hardware, transfer any bearings or seals, then refit the new knuckles with the stock screws. Once fitted, check for free suspension travel and re-evaluate toe and steering throw as needed to match your setup goals.

Tuning guidance: aluminium knuckles can change steering feel, so adjust shock damping or toe settings to fine-tune handling for quicker turn-in or more stable mid-corner behavior.

How will these affect steering precision?

The reduced pivot flex typically yields crisper steering inputs, so expect quicker response; small steering trim or toe adjustments may be required to dial in the balance you prefer.

Should I change shocks after fitting these?

Not mandatory, but you may benefit from slightly softer damping or incremental spring rate changes to offset the firmer steering feel when tuning for a particular terrain.

Do these require different link lengths?

They are intended to match stock geometry; retain existing linkage lengths unless you are purposely altering toe or ackermann setup for tuning reasons.

Copyright © 2008-2026 rcjaz.com.au All rights reserved