Element Enduro Steering Upgrade - Front Aluminum Knuckle Arms JR-EE01-GU by Jazrider  [JR-EE01-GU]

Element Enduro Aluminum Front Steering Knuckle Arms Set (Gun Metal)
Price:
AUD$15.47
Brand:
JAZRIDER
Model:
JR-EE01-GU
Condition:
Brand New
Write a review

Trail-focused aluminum steering knuckles for Element Enduro

This JR-EE01-GU set of aluminum front steering knuckle arms is offered as an aftermarket replacement for Element Enduro trail trucks. Machined construction reduces the flex seen in molded parts and helps maintain consistent steering geometry when the chassis is loaded. The gun metal finish provides a subdued, scale-appropriate look.

Installation notes: these arms fit the stock steering assembly points. Inspect and reuse original fasteners unless a specific upgrade screw set is required by your chassis guidance. Basic tools—a hex driver and a torque-aware driver—are sufficient for normal installation.

Tuning notes: metal knuckles tighten steering response and can improve precision on technical lines. Because they reduce linkage compression, check servo power and travel and adjust linkage geometry to avoid interference at full lock.

Compatibility

  • Element Enduro

How will steering feel change after fitting these?

Expect crisper, more immediate steering feedback with less compliance in the linkage, which helps on technical trail obstacles but can feel harsher if not set up correctly.

Do I need a stronger servo when using aluminum knuckles?

Not necessarily, but confirm your servo can handle the reduced play and any increased loads; higher torque servos improve control when steering forces rise.

Should I change toe or linkage settings after installation?

Re-check toe and linkage geometry after fitting; the reduced flex can reveal small misalignments that may cause binding at extreme steering angles.

Copyright © 2008-2026 rcjaz.com.au All rights reserved