This item is an RC-scale caster block hub set intended for the Element Enduro Trail Truck chassis, listed under model JR-EE02-BK. The kit swaps the stock caster block zone for machined aluminum components to alter steering rigidity and chassis feedback without implying use across full vehicle ranges.
Compatibility is specific to the Element Enduro Trail Truck as noted; choose this set when a firmer caster block mounting point is wanted to affect steering behaviour on trail-focused setups. Do not assume fit with other Element or unrelated models unless explicitly confirmed.
Fitting is a direct-replacement process: detach the existing caster block parts, carry over any reusable screws and steering linkages, install the aluminum hub components into the original mounting points, and check wheel and suspension clearance. Post-install, verify steering travel and toe alignment prior to operating the model.
From a setup viewpoint this component changes local stiffness at the front knuckle area and will influence how steering and suspension inputs are relayed. Pair the hub set with serviceable ball bearings and reassess front preload to balance handling and component wear.
Copyright © 2008-2026 rcjaz.com.au All rights reserved
