Elevator Lever Rod Replacement for Hirobo Eagle, Freya, EX, SX Models HI0404620  [HI0404620]

HIROBO 0404-620 EAGLE ELEVATOR LEVER ROD SET #0404620
Price:
AUD$15.90
Brand:
Hirobo
Model:
HI0404620
GTIN:
4512895108618
Condition:
Brand New
Write a review

Replacement Elevator Lever Rod Assembly

This Hirobo HI0404620 elevator lever rod set is a replacement assembly aimed at restoring elevator linkage accuracy on Hirobo Eagle series helicopters. It reconnects servo movements to the elevator mechanism, helping retain precise control inputs.

Fitters should check each rod for straightness, ensure ball joints operate without binding, and confirm proper thread engagement before the first flight after replacement. Proper linkage alignment improves tuning repeatability and reduces unwanted play during aggressive control inputs.

Compatibility

  • Eagle
  • Freya
  • EX
  • SX

How does this affect flight tuning?

Replacing worn rods restores linkage geometry, which can make pitch response more consistent and simplify trimming and cyclic tuning during setup sessions.

Is additional hardware needed to fit these rods?

No extra specialised parts are normally required; you will typically need basic tools and the original mounting hardware. Verify fastener sizes and replace any damaged threads before final assembly.

What final checks are recommended post-install?

Confirm elevator neutral and smooth travel, check for any binding across the range, and conduct a cautious hover test at low throttle to validate control behavior under load.

Copyright © 2008-2026 rcjaz.com.au All rights reserved