Embla EB Control Arm for Elevator - Hirobo HI0304142  [HI0304142]

HIROBO 0304-142 EMBLA EB ELEVATOR LEVER #0304142
Price:
AUD$19.23
Brand:
Hirobo
Model:
HI0304142
GTIN:
4512895156718
Condition:
Brand New
Write a review

Elevator control arm designed for Embla EB

This component is an RC replacement elevator lever intended for the Embla EB helicopter series. It connects the servo output to the elevator linkage and provides the mechanical leverage needed for pitch inputs.

Installation follows a simple routine: remove the old lever from the servo output, attach the replacement at the same spline position, restore neutral linkage geometry and check travel limits prior to flight. Conduct ground checks to confirm elevator neutral and endpoint travel and avoid any over-travel issues.

Regarding setup, the lever affects leverage and effective throw; using a correctly fitting lever helps refine elevator feel and allows finer adjustments when trimming the model.

How does this lever affect elevator throw and feel?

The lever changes the mechanical advantage in the linkage; swapping to a worn or differing arm can alter throw and response, so replace or adjust it to fine-tune elevator movement.

When is it appropriate to replace the elevator lever?

Replace the lever if you see visible wear, looseness or if fitment is degraded, as these conditions can degrade control precision and reliability.

Will swapping the lever require changes to the swash or linkage setup?

Minor adjustments to linkage geometry or servo endpoints may be necessary after fitting; always re-check neutral and endpoint travel and tweak as required during setup.

Copyright © 2008-2026 rcjaz.com.au All rights reserved