EMBLA SZM2 Tail Slide Interface - HI0304117 by Hirobo  [HI0304117]

Tail Link Slide Block for EMBLA SZM2 - Overview

The Hirobo HI0304117 slide block functions as a replacement sliding element for the EMBLA SZM2 helicopter, sitting within the tail or control linkage to preserve alignment during inputs and trims. Its design targets consistent, low-friction movement to reduce play.

Intended fit is for EMBLA SZM2 specific configurations; confirm your model designation prior to purchase. This slide point helps maintain predictable control feel when you adjust tail response or trim settings.

Fitting steps: remove the relevant access panel, release retaining screws, and orient the new slide block to mirror the removed component. Verify there is no binding and that the block moves freely before reassembly; tighten fasteners to the recommended torque to avoid crushing the part.

Adjustment advice: use the slide block to dial in tail-centre alignment and limit lateral slack. Make precise, incremental moves and verify results with cautious hover checks before full-throttle flying.