E-Station Balance Cable Compatible with POLYQUEST/HYPERION BC5/BC6/PB5/PB6 - Bantam CSEAC123  [CSEAC123]

BANTAM BALANCE CONNECTION CABLE (POLYQUEST/HYPERION) FOR E-STATION BC5/BC6/PB5/PB6 #EAC123
Price:
AUD$5.38
Brand:
Bantam
Model:
CSEAC123
Condition:
Brand New
Write a review

Connector and fit details for E-Station chargers

The Bantam CSEAC123 is a purpose-built balance connection cable for POLYQUEST and HYPERION equipment, specified for E-Station BC5, BC6, PB5, and PB6 chargers. It serves as the link between the charger's balance port and a battery's balance pins to preserve correct cell balancing during charge cycles.

Confirm your charger is an E-Station BC5/BC6/PB5/PB6 model and that the target battery uses the matching Polyquest/Hyperion balance connector before use. Installation is typically plug-and-play: insert the cable into the charger balance outlet and then into the battery's balance connector, ensuring a secure connection to prevent intermittent contact.

During use, route the cable away from drive components and heat sources, visually inspect connector seating before each session, and avoid stressing the wire at the plug junction. This lead handles routine balancing and charging tasks as part of safe RC battery handling.

What should I check if the charger does not detect the balance plug?

First confirm the cable is seated fully at both ends, inspect pins for damage or debris, and ensure the charger model is one of the E-Station BC5/BC6/PB5/PB6 series. Replace the lead if pin damage is present.

Any routing advice to avoid heat or mechanical wear?

Keep the cable away from exhausts, motors, and linkages, secure it with a tie if necessary, and avoid tight bends at the connector to reduce wear and intermittent faults.

Copyright © 2008-2026 rcjaz.com.au All rights reserved