Factory Pro Al. FP-M-AC3105SV 7075 Aluminum Precision Shims 3x9x0.5mm Silver (8pcs)  [FP-M-AC3105SV]

Price:
AUD$9.99
Brand:
Factory Pro
Model:
FP-M-AC3105SV
Condition:
Brand New
Write a review

Precision Shimming with Factory Pro 7075 Spacers

For racers and kit tuners who want reliable alignment, the Factory Pro Al. FP-M-AC3105SV 7075 spacer set is a practical choice. These silver 3x9x0.5mm aluminium pieces are supplied in packs of eight and suit a variety of suspension and drivetrain spacing needs.

Material Advantages of 7075

7075 aluminium offers a strong, lightweight profile that resists deformation under load. That means your small setup changes remain consistent lap after lap, and the shims hold tight where steel or softer alloys might wear.

Common Installation Uses

These spacers work well on many 1/10 scale models for tasks like trimming steering geometry, taking up slack in hubs, or fine-tuning ride height. Their standard sizing makes them easy to drop into common hub and link assemblies.

How do I check spacer fit before final assembly?

Trial-fit the shim onto the shaft or inside the bore, then rotate the assembly to confirm no binding; adjust or remove shims if there is contact with moving parts.

Can these be used on both plastic and metal hubs?

Yes, they are compatible with plastic and metal components; just ensure mating surfaces are free of burrs and that fasteners are torqued to the correct spec.

Should I lubricate the spacer contact area?

A light film of anti-seize or thin grease on mating surfaces can prevent galling and make future adjustments easier, especially on aluminium-to-aluminium interfaces.

Copyright © 2008-2026 rcjaz.com.au All rights reserved