Factory Pro FP-O-AP0002 33T 48 Pitch Spur for O-AP0001 Tamiya Chassis  [FP-O-AP0002]

Factory Pro FP-O-AP0002 Spur Gear 48Pitch 33T (for O-AP0001)
Price:
AUD$12.10
Brand:
Factory Pro
Model:
FP-O-AP0002
Condition:
Brand New
Write a review

Factory Pro Spur Gear for Better Drive Feel

The Factory Pro FP-O-AP0002 Spur Gear is compatible with Tamiya M05, M06, M07 and M08 platforms and features a 48 Pitch 33T count for predictable power delivery. It is a practical replacement or upgrade for hobbyists wanting consistent engagement.

Compatibility Notes

Made to work with the O-AP0001 arrangement, this spur gear matches the tooth profile expected by the specified Tamiya models. Its tolerance control helps reduce slop and unwanted noise from the drivetrain.

Installation and Care

Ensure correct mesh by testing rotation under light load and adjusting pinion position. Keep the gear free from grit and reapply a light coat of grease to the teeth for long service life.

Will this fit my Tamiya M06 out of the box?

Yes, the FP-O-AP0002 is made to fit the O-AP0001 setup used on the listed Tamiya models with no modification in most cases.

Can I run this on mixed surface tracks?

The gear works well on a variety of surfaces; just check mesh and clean after runs on abrasive or dirty tracks to avoid accelerated wear.

Any tips for long term durability?

Keep the mesh correct, avoid overtightening the spur nut, and inspect for chipped teeth after impacts to maintain long term durability.

Is lubrication necessary on the spur teeth?

A light smear of gear grease helps reduce friction and wear; avoid excess that can attract dirt.

Copyright © 2008-2025 rcjaz.com.au All rights reserved