XRAY T4-20 Front-End Graphite Shock Tower - Factory Pro O-XCP001  [FP-O-XCP001]

Price:
AUD$12.77
Brand:
Factory Pro
Model:
FP-O-XCP001
Condition:
Brand New
Write a review

Graphite tower for front shocks on T4-20

This is a graphite front shock tower produced as a replacement for the XRAY T4-20 chassis, sold under Factory Pro O-XCP001. It secures the front shocks and enables alternative mounting positions that influence overall suspension geometry.

Use this component only for model car suspension repair and setup. Fitting changes the shock mounting layout and can affect roll centre and leverage ratios, so validate any adjustments through test running. Graphite brings a stiffness to weight ratio commonly used in 1:10 touring car upgrades.

Installation guidance: remove the stock tower according to your chassis service steps, align the new tower to the same datum points, and re-use factory hardware if still serviceable. After install, check for clearance at the servo and suspension arms, align shock shafts, and tighten progressively while evaluating handling on short runs.

Will O-XCP001 work with aftermarket shock mounts

It is compatible with standard T4-20 shock geometry; if you run aftermarket mounts check hole spacing and clearances before committing to the fitment.

Any recommended setup changes after swapping towers

Small adjustments to camber, toe and shock position are common. Make incremental changes and use short test runs to assess understeer or oversteer tendencies.

How to check installation alignment

After fitting, verify the tower sits flush to the chassis, check that shock shafts are parallel to the shock bodies, and confirm there is no binding in suspension travel.

Copyright © 2008-2026 rcjaz.com.au All rights reserved